"Red Mosquito" Scented Candle

CARE FOR SPINNERS

Keep it dry: Moisture is the enemy of metal bearings. If your spinner gets wet, dry it immediately with a soft cloth or a hair dryer on a cool setting to prevent rust.

Clean the bearings: If the spin starts to feel "gritty" or slows down, dust has likely moved in. Pop the caps off and use a compressed air can to blow out debris. For a deeper clean, a quick soak in high-percentage isopropyl alcohol (90%+) usually does the trick.

Skip the WD-40: It’s a common mistake, but standard lubricants like WD-40 or cooking oils actually attract more dust and gunk over time, eventually slowing the spinner down. Use 1 drop and no more of sewing machine oil on the bearing.

Check for loose parts: Spinners often have threaded caps or weights. Give them a gentle twist every now and then to ensure nothing is unscrewing itself mid-spin.

Avoid "dry firing" onto hard surfaces: Dropping a spinner while it's at max RPM can misalign the internal balls in the bearing or dent the outer shields. Try to keep your tricks over a carpet or a bed.

Storage matters: When you aren't using it, keep it in a small pouch or a dedicated pocket. Tossing it loose into a bag with keys and coins is a recipe for scratches and lint infiltration.

CARE FOR SLIDERS

Wipe the contact plates: Use a microfiber cloth to clean the sliding surfaces daily. Even a tiny speck of skin oil or pocket lint can create "drag," making the slide feel sticky rather than smooth.

Check for "Metal Dust": Over time, metal-on-metal sliders can produce a fine grey powder. Wipe this away frequently to prevent it from acting as an abrasive that scratches the finish.

Manage the Magnets: If your slider has exposed magnets, ensure they haven't come loose. If one wiggles, a tiny drop of super glue can reset it—just make sure the polarity is facing the right way before it dries!

Use Tape for a "Quiet" Slide: If the clicking is too loud for an office or classroom, apply a thin layer of PTFE tape(Plumbers Tape) to the contact surfaces. This dampens the sound and makes the movement feel buttery smooth.

Avoid Liquid Lubes: Much like spinners, oils and greases usually make sliders "gummy." If you must lubricate for speed, use a dry film lubricant or a tiny bit of graphite powder.

Mind the Drop: Magnetic sliders can sometimes fly apart if dropped on a hard floor. Try to fidget over soft surfaces to avoid chipped magnets or dented corners.